FAAC Gate Repair Nationwide | Gatewood Fence & Gate

FAAC Gate Repair in Tarzana: What to Know First

FAAC gate repair in Tarzana typically runs $180 to $420 for common failures like capacitor swaps, limit switch resets, and hinge realignment, with most jobs done same day or next morning. We’re an independent FAAC service provider, not an authorized dealer, which means we fix the board instead of telling you it’s obsolete and quoting a whole new operator. If your FAAC gate is grinding, stalling mid-cycle, or won’t hold position, call us at (818) 514-7606 and we’ll tell you over the phone whether it sounds like a ten-minute fix or a real job.

Call (818) 514-7606

This page is for Tarzana homeowners who own a FAAC swing or slide gate operator and want to know what’s actually wrong before anybody touches it. Hal Gatewood has been working on FAAC gates here since 2001, and he’ll tell you plainly what wore out and what it costs to make it right.

How FAAC Products Fail - and How We Fix Them

FAAC builds a solid operator. Where they fail has more to do with how they’re installed and what the Tarzana heat does to them than any inherent flaw. Here’s what we see on service calls week after week:

• FAAC 400 and 402 swing operators: capacitor failure from heat soak. The capacitor sits inside a housing that bakes in the San Fernando Valley sun. After four or five Tarzana summers, the cap dries out and the gate moves halfway, groans, and stops. We replace it with a cap rated for the same microfarad value, test under load, and you’re done. We don’t upsell a new board for a $30 part.
• FAAC 750 and 760 slide gates: limit switch drift. These units use magnetic limit switches that loosen over time from vibration. The gate overtravels, slams the stop, and faults out. We reposition the limits, torque the mounts, and run a full cycle test. Takes an hour. Not a new motor.
• FAAC E024S control boards: phantom faults from low voltage. Tarzana neighborhoods with older service panels drop voltage when air conditioners kick on in July. The E024S logs a “stop circuit” error that has nothing to do with the stop circuit. We test the incoming line voltage before chasing ghosts in the board. That’s the difference between a diagnosis and a guess.
• FAAC hydraulic operators: bypass valve creep. We still see a few older FAAC hydraulic units on larger estate gates south of Ventura Boulevard. When the bypass valve wears, the gate drifts open an inch every hour and the safety photocell eventually faults. We adjust or replace the valve rather than condemning the whole operator.
• FAAC swing arm geometry: the thing nobody adjusts until the hinge is already gone. If the arm’s pivot points aren’t square to the gate leaf, every cycle torques the hinge post. We see this on Tarzana gates installed by landscapers who didn’t have a level. We correct the arm geometry, then weld-reinforce the hinge before it tears out of the post. Fix the arm without checking the post and you’ll be calling again by spring.

Our FAAC Gate Repair Process

Here’s what happens when you call us about a FAAC gate that’s misbehaving:

1. 1
   You call, a person answers. Not a voicemail, not a menu tree. We ask what the gate’s doing, what model operator you have if you know it, and whether it’s stuck open or stuck closed. Hal decides if it’s an emergency call or a scheduled visit.
2. 2
   We show up with FAAC parts on the truck. Capacitors, limit switches, photocells, control board fuses, hydraulic seals, and a bin of OEM hardware. We stock for the models Tarzana homes actually have, not whatever’s on a national supply chain spreadsheet.
3. 3
   We diagnose before we touch anything. Voltage check at the board, mechanical test of the gate leaf by hand, visual on the hinge posts and arm geometry. We tell you what we found, what it costs, and what can wait. The price is quoted and agreed before any work starts. Always.
4. 4
   Parts decision: OEM or quality aftermarket. For control boards and safety devices we use FAAC original parts. For capacitors, limit switches, and hardware, we’ll offer a quality aftermarket option if it’s honest money saved and the same reliability. We tell you the difference and let you decide.
5. 5
   Repair, test, clean up. We run the gate through ten full cycles, check force settings so it won’t crush a kid or a dog, verify the safety edges and photocells, then wipe down the housing. You test it too, with us standing there.
6. 6
   Everything’s in writing. The invoice lists every part and the 90-Day Done Right Promise is printed right on it. If it acts up within 90 days, Hal comes back. No runaround, no “that’s a different problem.”

What FAAC Gate Repair Costs in Tarzana

Straight numbers, based on what we actually charge in Tarzana and the neighboring Valley communities:

• Capacitor replacement (FAAC 400/402): $180-$260
• Limit switch adjustment or replacement (FAAC 750/760): $195-$285
• Control board repair or replacement (E024S): $320-$480
• Hinge realignment with on-site welding: $350-$600 depending on post condition
• Photocell or safety edge replacement: $140-$220

What moves the price: how long the gate’s been running with the problem (deferred repairs chew up more parts), the gate’s weight and leaf size, and whether the post or hinge pad needs welding. We don’t charge a trip fee inside the county, and every quote is free. Call us for an exact number, not a ballpark that shifts once the truck rolls up.

Why Tarzana Homeowners Call Gatewood Fence & Gate for FAAC Work

Hal Gatewood has been fixing gates in Tarzana since 2001. Most of his customers live within a few miles of Ventura Boulevard, and some have been calling him back for going on two decades. The name is on the shop, the shop is down the road, and that’s the oldest accountability there is. We weld on site so your gate never leaves your driveway, and we stand behind every job with our 90-Day Done Right Promise in writing, not buried in fine print. If your FAAC operator turns out to be a lost cause, we won’t pretend otherwise. But we also service LiftMaster, Mighty Mule, Ghost Controls, and DoorKing, so the recommendation we give you is based on your gate, not on what we happen to have on the shelf. And when you call at nine on a Saturday night because the gate won’t close, a live person answers. Hand me your number and I’ll call you when I’m on my way - none of that four-hour window stuff.

FAQs